Use Recommendations

For general washing of woollens, use GENTLE as a 1% solution in warm water.

GENTLE can also be used undiluted as a laundry pre-spray, or diluted with up to 4 parts of water for use as an ink remover and general spotter.

Safety Phrase

Refer Label, TDS or SDS

The post Gentle – Wool Wash & Spotter appeared first on Able Westchem.

Use Recommendations

LAUNDRY PRE SPRAY is safe to use and will not damage fabric. However, it is advisable to patch test coloured articles and denim before treating.

Spray or pour LAUNDRY PRE SPRAY undiluted onto the stain. For heavier stains, work with the fingers into stain. Allow 5 minutes for full activity, then wash normally.

Safety Phrase

Refer Label, TDS or SDS

The post Laundry Pre Spray – Stain Remover appeared first on Able Westchem.

Use Recommendations

Safety Phrase

The post Oxy 50 – Hydrogen Peroxide 50% Soln – Food Grade appeared first on Able Westchem.

Use Recommendations

OXY-BLEACH may be used in conjunction with conventional laundry powders in washing machines or as a pre-soak in hot water. It can be used during the suds cycle to supplement the washing action of a powder or soap, or simply to give an additional bleaching treatment to the articles before or after they have been washed. When properly used, OXY-BLEACH is safe on all fabrics.

As a pre-soak, use OXY-BLEACH at concentrations in the order of 12-18 grams per litre of hot water. Make sure that all the powder has dissolved before introducing the wash. Allow to soak some hours or overnight. At higher temperatures, use less OXY-BLEACH or shorter contact time. For lower temperatures use a higher concentration of OXY-BLEACH and longer soak time. For specific use concentrations and bleaching procedures, our Laundry Technical Department should be consulted.

Safety Phrase

Refer Label, TDS or SDS

The post Oxybleach – Nappy San Powder appeared first on Able Westchem.

Use Recommendations

SOLWASH was designed to be used in commercial laundries. It can be added manually to the wash or dispensed via electronic control systems.

If adding SOLWASH manually use 40-80ml per 50kg wash load for lightly soiled garments. Double this concentration if the garments are heavily soiled.

Electronic dispensing equipment can be installed and serviced by our fully qualified Service Technician.

Safety Phrase

Refer Label, TDS or SDS

The post Solwash – HD Laundry Detergent appeared first on Able Westchem.

Use Recommendations

Pre-Spotting

• Pour SPOT IT undiluted onto the stain.
• Allow 5 minutes for full activity.
• Then wash normally.

Removing graffiti

• Apply undiluted with a clean cloth or brush ink marks.
• Wipe clean.
• Care should be taken if used on painted or varnished surfaces.

Carpet spotting

• To remove chewing gum, first scrape off the bulk of the gum with a razor blade.
• Apply SPOT IT onto the remaining gum, allowing time to soften and dissolve.
• Wipe up with a clean cloth.

Removing grease and ink stains from carpets

• Apply SPOT IT onto the stains.
• Allow time to penetrate.
• Soak up with a wad of clean dry cloth or absorbent pad, taking care not to spread the stain by rubbing.
• Residual solvent may be removed using a mild detergent such as carpet care, carpet extraction detergent.

Safety Phrase

Refer Label, TDS or SDS

The post Spot It – Laundry Spotter appeared first on Able Westchem.